Shukou.com also known asTemplate-free networkIt is fixed as a consumable template.When the concrete is poured behind the formwork, the remaining corner pieces on the mesh are embedded in the concrete to form a mechanical wedge connected to the adjacent casting block.The quality of the seams is strictly controlled.Its bonding and shear strength is comparable to well-treated rough stitching.During secondary pouring, hole punching and wooling can be eliminated, which can shorten the construction cycle and increase the strength of the cast body.

Features:

1. Good mechanical properties and low side pressure

It is equivalent to 60% of the pressure that the general template bears, so it can reduce the amount of the template support keel.

2. Directly observe the pouring process

Because of its own special mesh, the casting project can be monitored by the naked eye, thereby reducing the risk of pores and honeycombs.

3. Light weight, easy transportation and installation

It is just one-tenth of the weight of ordinary fixed steel molds, fast installation and easy transportation.

4. Optimize the process and increase the shear interface

The mortar passes through during pouringMeshThe grid hole penetrates into the interface to form a coarse-grain interface with very ideal shear resistance.

5. Easy to penetrate and continuously tie steel bars

The porous nature of the closing net uses a dense special grid, and you can use steel bars below 12mm to pass through with a little force.Steel bars with slightly larger diameter can be cut open the grid, and the plate can be returned to position after the steel bars pass through.The Kuaiyi closing net can also be installed before binding the steel bars, and then pierced through its mesh holes to install.

6. Adapt to sectional pouring concrete, construction civilization

For permanent formwork, the next pour concrete can be bonded without removing the mold or making joints, so the interface preparation is simplified.

7. Easy to socket and crop

It has many properties, is easy to cut, and can be bent and formed according to the required support mold shape.