Non -woven wallpaper

Wallpaper foaming: Wallpaper foaming is a common problem. It is mainly because the unevenness of glue when paste the wallpaper causes the surface of the wallpaper on the surface of the wallpaper too much to separate the water from the grassroots level, so some built -in bubbles appear.In fact, the solution is very simple. As long as you use a general sewing needle to pierce the bubbles on the surface of the wallpaper, release the gas, and then use the needle tube to extract an appropriate amount of adhesive into the pinhole just now.Just accept it.

Wallpaper moldy: Molding the wallpaper usually occurs in the rainy season and humid weather, mainly because the wall water is too high.For the mildew, it is not too serious wallpaperSolutionAs follows: Wipe with a white towel with a white towel, or wipe it with soapy water.The best way is to go to the wallpaper shop to buy special mold removal agents.

Wallpaper tilted edge: wallpaper edges may beGrassroots treatmentNot clean, the adhesive adhesive is too low or bagCornerThe wallpaper is less than 2mm and so on. The solution: use the rubber powder of the wallpaper, wipe it on the side of the roller, smooth it up, usehair dryerBlow for about 10 seconds, then use it againHandleIn fact, until you stick, blow it with a hair dryer to dry.

Wipe of wallpaper: scrubbing with wet cloth or dry cloth; you cannot pollute the wallpaper with some colored raw materials, otherwise it is difficult to remove; wipe the wallpaper should start at the hidden corner or behind the door to avoid appearing to avoid appearingAdverse reactionsCause wallpaper damage